Laminate flooring is said to float because it is not fastened to the sub floor.
Why wont laminant floor lock correctly.
A warped or flawed piece of laminate a heaved or uneven subfloor a piece of debris trapped under the flooring or underlayment or in the flooring s grooves a protruding nail or screw head.
All the individual pieces interlock into one sheet that lays or floats on the sub floor.
Most modern laminate flooring does not require you to tap or pound it into place.
Although laminate flooring is not solid wood it still contains enough wood that the planks expand and.
If you hammer planks together that use this system you may break the edges and your floors will not lock correctly.
I laid about 200 sq ft laminate i didn t do too bad of a job but i missed 2 spots away from each other but still pretty center in the room where the boards just won t lock.
Some common reasons why laminate pieces won t snap into each other include.
In this video brian shows exactly how the pl.
Tapping tools leave mark on the laminate that destroy that board and you have to throw it out.
I have installed every laminate floor with nothing but my bare hands.
I tap from both ends i hammer down flat on the joint i air dusted it i checked that the won t stay together.
Not sealing laminate joints in water sensitive areas laminate flooring products are recommended for residential areas.
Have installed high end laminate and bargain basement all went together without any sort of tapping tool.
Using the caulk around door jambs pipes and stonework take your time to finish your work the right way.
Drop and lock is the second of the two main types of click together installation methods for laminate flooring.
When properly installed it should have a gap of approximately 1 4 inch from the walls of the room on all sides.
The design laminated on to the plank can chip at the edges if the planks are not cut properly.
Instead they use a system of locks that click together.
Problems with installing glueless laminate floors expansion.