Why Is My Laminate Floor Not Laying Flat

And don t forget to lay an underlay felt or a rubber composite type floor covering.

Why is my laminate floor not laying flat.

The block of wood can be a scrap piece of wood as long as it is flat on both sides. When you are installing snap and click laminate flooring you will need a soft rubber mallet and block of wood. All the individual pieces interlock into one sheet that lays or floats on the sub floor. When you remove the floor boards and replace them be sure to cover the subfloor with a layer of plastic or tarpaper so it doesn t happen again.

The most common cause of peaking is a lack of expansion space between the laminate floor and the walls around the perimeter of the installation or a lack of expansion space between the laminate floor and laminate moldings. Installers avoid it by laying a moisture barrier between the laminate and the subfloor. Some locking systems are can be damaged from the tapping. You must check and control the flatness.

Laminate flooring is said to float because it is not fastened to the sub floor. The bulges probably mean that the floor is not flat which means starting over again i m afraid. Very common installation mistake. Use caution when using a block of wood and a mallet on some laminate flooring.

This is a serious problem because it usually means the boards are damaged and need to be replaced. When properly installed it should have a gap of approximately 1 4 inch from the walls of the room on all sides. Not all vinyl plank flooring requires a glue down installation process. Also check for any damp areas this would swell the laminate if wood.